Brill 42 BM Manual Del Usuario página 24

Fault
Motor does not start.
GB
Engine starts up and
then stops.
Motor starts for a short time
then suddenly stops with a loud
bang.
Petrol leaks out when in
the parking position.
Lawn turning yellow,
cut not clean.
Mower leaves deep tracks.
11. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and / or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Always carry out a visual
inspection before use in order
to determine whether the cut-
ting tool is worn or damaged
and that no screws are loose.
Check the work area before
starting work. Remove any for-
eign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy footwear
and long trousers when working
with the appliance. Do not use it
24
Possible Cause
Primer was not operated
when starting the motor.
No fuel, fuel tank empty.
Spark plug defective or
fuel tank empty.
Tank cap valve not open
Ventilation in the tank cap
blocked.
Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Tank cap valve not open.
Blade is too blunt,
cutting height too low.
Ground softened by water,
lawn too wet.
when barefooted or only wear-
ing light sandals.
Warning! petrol is extremely
inflammable.
Only keep petrol in the container
provided for the purpose.
Always fill the tank outdoors
and do not smoke when filling
the tank with petrol.
Fill up with petrol before starting
the engine.
Stop the engine before topping
up.
Never open the tank cap or top
up with petrol whilst the engine
is running or the equipment is
hot.
For safety reasons, do not attempt
to start the engine if the petrol
has overflowed. Instead, remove
Remedy
Press the primer several times
(see Putting your Lawnmower
into Operation).
Clean spark plug and / or
fill the fuel tank.
Valve in the tank cap valve open
– clean the drill hole in the tank
cap from the inside using
a pointed object.
– Contact specialist workshop /
service centre.
Motor overhaul at specialist
workshop required.
Close the valve in the tank cap.
Change blade and / or use
a slightly higher cutting height.
Allow lawn to dry,
do not mow if grass is wet.
the equipment from the area con-
taminated with petrol. Doe not
make any attempt whatsoever to
start the engine until all the
petrol vapours have evaporated.
For safety reasons, the petrol
tank and tank cap must be
replaced if damaged.
Always replace damaged
exhaust components.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools
replaced by Brill Service or your
authorised specialist dealer.
Use /
A
Responsibility
Warning! The safety
A
devices installed on the
appliance by the manufacturer