Warranty - Brill 42 BM Manual Del Usuario

are neither to be removed nor
bypassed as this can result in
injury.
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working. Never start the
equipment whilst tilted – risk of
injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Never permit the combustion
engine to run in enclosed spaces
where dangerous exhaust gases
can collect.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Make sure that the air vents are
free of dirt.
Ensure that you are standing
safely and on firm ground, even
on a slope.
Work across the slope, never up
and down.
Do not work on excessively
steep slopes.
Be careful if you change direc-
tion on a slope, turn the

Warranty

The manufacturer warrants its
products for exclusively non-com-
mercial use for a period of
24 months from the date of
original purchase. This warranty
does not affect statutory war-
ranty claims. The warranty
machine round or draw it
towards you.
Be careful if you are going back-
wards, risk of stumbling!
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when trans-
porting it over surfaces other
than grass and if you are trans-
porting the equipment backwards
and forwards to the work area.
Never use the appliance if the
protective devices are not
mounted or if they are damaged.
Never change the basic settings
of the machine or rev the engine
too hard.
Disconnect all the cutting tools and
drives before you start the motor.
When starting or operating the
starter switch take care as stipu-
lated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the
cutting tool.
When starting or switching on the
motor, the machine should not
be tilted unless the machine has
to be raised during the process.
In this case only tilt it as far as
absolutely necessary and only
raise the side away from you.
Do not start the motor when you
are standing in front of the dis-
charge duct.
covers all substantial faults of
the product, which are caused
by defects in material and work-
manship. If a product exhibits
such a defect we will, at our
option, repair or replace it with-
out cost for parts and labour
Keep your fingers and feet away
from the cutting tool!
Keep your hands and feet away
from the interior housing and
discharge when the motor is run-
ning.
Never lift or carry a machine
with the motor running.
Each time you have to work on
the machine or leave it or top it
up, always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Remove the spark plug.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to vibrate
strongly, remove the spark plug
and ascertain the cause.
A
Taking a Break
Never leave the equipment unat-
tended. If you stop work, switch
the machine off and remove the
spark plug.
If you stop work to go to a dif-
ferent work area, it is essential
to turn the equipment off and
remove the spark plug.
Beware of Environmental
A
Influences
Comply with local quiet periods
in your community!
provided the following require-
ments are fulfilled:
The product must have been
.
sold to the customer in a
legally correct way.
The original receipt with the
.
customer's address, date of
GB
25