Festo MTR−DCI−42 Manual De Instrucciones página 24

5 Menu structure (control panel)
Menu commands
Diagnostic
Pos.set table
Axis param
System param
Software
information
1) 2)
Positioning
Move pos. set
Demo pos. table
Homing
1) 2)
Settings
Axis type
Axis param p
24
Description
Display the system data and the currently effective
settings
Display the position set table
Display axis parameters and data
Display system parameters and data
Display the operating system version (firmware)
Reference travel and positioning travel for testing
the position sets
Start positioning travel Position set"
Start positioning travel Position set table"
Start reference travel
Select the drive, parametrizing, programming the
position sets
Type DMES−...
Rotation drive
User config
3)
Zero point
3)
Abs.min.pos
3)
Abs.max.pos
Save...
1)
Festo linear axis with servo drive
type DMES−...
Rotation axis with stop
Any linear drive
Offset of axis zero point
Stroke limitation: Software end
position,
negative
Stroke limitation: Software end
position, positive
Save parameter in EEPROM
Festo P.BE−K−MTR−DCI 0411NH English