Festo MTR−DCI−42 Manual De Instrucciones página 25

Menu commands
Homing param
Position set
Password
1)
HMI control
LCD adjustment
1)
If necessary password protection
2)
Control interface must be deactivated, see [HMI control]:HMI=on
3)
Teach mode
Festo P.BE−K−MTR−DCI 0411NH English
Description
Homing
method
Velocity v_sw
Velocity v_s0
Save...
Position no.
Pos set mode
3)
Position
velocity
Save...
Set up a local password with 3 figures for the control
panel
Preset the device control via the control panel
Turn the display in 90° degree steps
Select referencing method (stop,
software limit switch...)
Positioning speed for searching for
the reference point
Positioning speed for moving to the
axis zero point
Save parameter in EEPROM
Number of the position set (0...14)
Set status: absolute or relative
positioning
Target position of the position set
Positioning speed of the position
set
Save parameter in EEPROM
25