Change Date; Start / Stop; Reset Partial Data - Ingeteam INGECON SUN 2.5 TL Manual De Usuario

3.7 Date change
This menu can be used to change the current time and date. The internal
clock automatically changes between summer and winter time.
OK key is pressed, the top of the display flashes in the
Each time the
following order: hour; minutes; day; month; and year, to show the present
value.
Use the up and down keys
value of any part of the time or date. By clicking on OK when the year
is flashing, the new date and time are changed. The following message
is then displayed:
Click on OK once more, to confirm the selection.
3.8

Start / Stop

This menu can be used to manually start or stop the operation of the inverter.
The Run or Stop status will not change even if the power supply to the inverter is cut off.
Click on OK to change from one status to the other. The following message will be displayed:
Select the desired option and click again on OK .
The stop status is maintained until the menu is accessed once more.
12:00
MAIN MENU

Change date

Start / Stop
Partial Data Reset
Change inv number
3.9

Reset Partial Data

This menu serves to zero the partial counters: EPar, T.ConPar and N.ConP.
Click on OK to zero the counters. The following message will be displayed:
Click on OK once more, to confirm the selection.
12:00
MAIN MENU
Change date
Start / Stop
Partial Data Reset
Change inv number
Page 20 of 68
and respectively, to change the
12/04/10
12/04/10
INGECON® SUN LITE
12:00
MAIN MENU
Monitoring
Configuration
Language
Change date
12:00
CHANGE DATE
Confirm (OK)
Cancel (ESC)
12:00 09/01/09
START / STOP
Confirm (OK)
Cancel (ESC)
12:00
PARTIAL DATA RESET
Confirm
(OK)
Cancel (ESC)
User Manual
AAY2000IKE01
12/04/10
09/01/09
09/01/09
AAY2000IKE01
Rev. _
Date: March 2011