Intended Use; Noise/Vibration Information; Technical Data - Würth MKB 35 Traducción Del Manual De Instrucciones De Servicio Original

Intended use

The machine is designed for drilling workpieces with
magnetisable materials using core drills and solid
drills for commercial use in industrial and workshop
environments.
The machines can be used horizontally, vertically
and overhead.
Any other use or use beyond this scope is consid-
ered improper use.
The user is solely responsible for damage
resulting from improper use.
Device elements (Fig. I)
1 Star handle
2 Magnetic sensor LED
3 Motor LED
4 Lever for magnet
5 Operating panel
6 Safety tab
7 Mains cable
8 Recess for safety harness
9 Motor O
10 Motor I
11 Magnetic base
12 Weldon quick-change holder /
Weldon holder
13 Sliding carriage and setting screws for adjust-
ment on the rear side
14 Drive motor
15 Coolant container
16 Magnetic switch

Noise/vibration information

Emission values
These values enable the estimating of the noise
emissions of the power tool and comparison with
various power tools. Dependent on the conditions
of use, state of the power tool or attachments, the
actual loading may be greater or smaller. When
estimating also take into consideration work breaks
and phases with lower loading. Specify protective or
organisational measures for the user based on the
appropriately adjusted estimation values.
Noise emission
Vibration on the
handle:
92 dB(A), 300 mm
distance from motor
AC=3,5 mm/s²
WARNING!
The noise level may exceed 80 dB (A)
during work.
Risk of severe injuries and acoustic
Â
trauma.
Wear hearing protection.
¾

Technical data

MKB 35-
Parameter
COMFORT
Mains voltage:
Power consumption:
Load speed:
Weight: 10 kg
Tool holder: 19 mm
Weldon
Coolant supply:
Magnetic force: 7,500 N
Tool force
- on 10 mm steel: 2,800 N
- on 6 mm steel: 2,300 N
Hole diameter max. in steel
- Core drill:
- Twist drill: Up to ø13 mm
DIN 338
Lowering:
Cutting depth:
Lift: 105 mm +
80 mm height
adjustment
on the sliding
carriage
Magnetic base size: 72 x 190 mm
Min. material 3 mm
thickness:
MKB 35
230 V, 50/60 Hz
1,100 W
450 rpm
10.6 kg
19 mm Weldon
direct holder
Integrated
9,000 N
2,100 W
–
12–35 mm
1–6 mm
DIN 338,
6–13 mm
DIN 1897
ø 10–40 mm
50 mm
120 mm
70 x 185 mm
Min. 6 mm
15