Kit Preparation; Kit Assembly - Metra 95-5701 Manual De Instrucciones

KIT PREPARATION

1. Cut the sub-dash and factory trim panel
to allow room for the radio assembly.
Note: See detail for proper cut in area
indicated. (Figures A, B)
2. Cut and remove the radio support brace
in the top of the sub-dash.
Continue to Kit Assembly
Remove shaded areas
(Figure A)
Detail
Remove shaded area
(Figure B)

KIT ASSEMBLY

1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra. Test
the radio for proper operation.
3. Remove the upper (2) 9/32" screws
securing the climate controls. Secure
the radio assembly to the dash using
the climate control screws.
4. Attach the (2) clips provided onto the
95-5701 radio trim panel. Clip the panel
onto the dash and radio brackets to
complete the installation. (Figure B)
(Figure A)
(Figure B)
REV. 7/16/2021 INST99-3024B
3