Peavey MAX Serie Manual De Operación página 23

THE BOTTOM LINE: using the effect will make the lowest notes you can possibly play sound unbeliev-
ably loud and clear. Practice with headphones is no longer a compromise. It even works with chords!
HINT: For best results, try using the effect without boosting the LOW control to extreme settings. This
will make the effect more apparent.
VOLUME
12
This knob controls the overall volume of the amplifier.
TUNE/MUTE
13
Pressing this button will engage the chromatic tuner while muting the output to the speaker. The LED
screen will indicate which note is being played while the red and green LEDs above the screen indicate
whether the note is flat (red), sharp (red) or in tune (green). This switch also mutes the DI.
AUX INPUT
14
This 1/8" input jack allows you to connect a CD player or MP3 player to your MAX Series bass amp
and play along
HEADHPHONE OUTPUT
15
1/8" headphone output for personal monitoring.
POWER SWITCH/DDT
16
This dual-purpose switch is used to turn the amp on and off. When the DDT (Distortion Detection
Technique) senses power amp clipping, a protection circuit is engaged and the LEDs in the power switch
change to red.
CAUTION: The on/off switch in this unit does not break both sides of the primary mains. Hazardous
energy can be present inside the chassis even when the on/off switch is in the OFF position.
Rear Panel
AC POWER INLET:
17
This is the receptacle for an IEC line cord, which provides AC power to
the unit. Connect the line cord to this connector to provide power to the
18
unit. Damage to the equipment may result if improper line voltage is
used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for
your safety. If the outlet used does not have a ground pin, a suit-
able grounding adapter should be used, and the third wire should be
grounded properly. To prevent the risk of shock or fire hazard, always
make sure that the amplifier and all associated equipment is properly
grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-
ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel-
low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored
green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is
marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the
terminal that is marked with the letter L, or the color red.
INDICATOR LIGHT
™
17
18