Personal Safety; Power Tool Use And Care - RIDGID K-400 Manual De Instrucciones

• When operating a power tool outdoors,
use an extension cord suitable for out-
door use. Use of a cord suitable for out-
door use reduces the risk of electric shock.
• If operating a power tool in a damp loca-
tion is unavoidable, use a ground fault
circuit interrupter (GFCI) protected sup-
ply. Use of a GFCI reduces the risk of
electric shock.

Personal Safety

• Stay alert, watch what you are doing
and use common sense when operat-
ing a power tool. Do not use a power
tool while you are tired or under the in-
fluence of drugs, alcohol or medica-
tion. A moment of inattention while operat-
ing power tools may result in serious per-
sonal injury.
• Use personal protective equipment.
Always wear eye protection. Protective
equipment such as dust mask, non-skid
safety shoes, hard hat, or hearing protec-
tion used for appropriate conditions will
reduce personal injuries.
• Prevent unintentional starting. Ensure
the switch is in the OFF-position before
connecting to power source and/or bat-
tery pack, picking up or carrying the
tool. Carrying power tools with your finger
on the switch or energizing power tools
that have the switch ON invites accidents.
• Remove any adjusting key or wrench be-
fore turning the power tool ON. A wrench
or a key left attached to a rotat ing part of the
power tool may result in personal injury.
• Do not overreach. Keep proper footing
and balance at all times. This enables
better control of the power tool in unex-
pected situations.
• Dress properly. Do not wear loose cloth-
ing or jewelry. Keep your hair and cloth-
ing away from moving parts. Loose
clothes, jewelry or long hair can be caught
in moving parts.
• If devices are provided for the connec-
tion of dust extraction and collection
facilities, ensure these are connected
and properly used. Use of dust collection
can reduce dust-related hazards.
• Do not let familiarity gained from fre-
quent use of tools allow you to become
complacent and ignore tool safety prin-
999-998-156.09_REV. E
K-400 Drain Cleaning Machine
ciples. A careless action can cause se-
vere injury within a fraction of a second.
• This appliance is not intended for use
by persons (including children) with re-
duced physical, sensory or mental capa -
bilities, or lack of experience and knowl-
edge, unless they have been given su-
pervision or instruction concerning use
of the appliance by a person responsible
for their safety.
• Children should be supervised to en-
sure that they do not play with the appli-
ance.

Power Tool Use and Care

• Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better and
safer at the rate for which it was designed.
• Do not use the power tool if the switch
does not turn it ON and OFF. Any power
tool that cannot be controlled with the switch
is dangerous and must be repaired.
• Disconnect the plug from the power
source and/or remove the battery pack,
if detachable, from the power tool before
making any adjustments, changing ac-
cessories, or storing power tools. Such
preventive safety measures reduce the risk
of starting the power tool accidentally.
• Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tool's op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
caused by poorly maintained power tools.
• Keep cutting tools sharp and clean. Pro -
perly maintained cutting tools with sharp
cutting edges are less likely to bind and
are easier to control.
• Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for oper-
ations different from those intended could
result in a hazardous situation.
3