Kit Assembly; Kit Preparation - Metra 99-7343 Instrucciones De Instalación

1. Snap the A/C vents into the A/C
vent trim panels. (Figure A)
2. Attach the left and right A/C
vent trim panels and the climate
controls to the main radio housing
panel using the provided (10) #8 x
1/2" Phillips screws and (2) #8 x
1/4" Pan head screws. (Figure B)
3. Snap the hazard switch into the
main radio housing. (Figure C)
4. Attach the passenger air bag light
to the main radio housing using
(2) #8 x 1/2" Phillips screws.
(Figure D)
5. Attach the display brackets to the
display and mount it back into the
dash in the factory location.
(Figure E)
Continue to next page

Kit Assembly 99-7343

Kit Preparation

(Figure A)
(Figure B)
(Figure C)
Note: #8 x 1/4" Pan
head screws must
be installed in the
indicated locations.
4
(Figure D)
(Figure E)