Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 143
BASIC - Special functions
1. Open menu

4. Set parameter

Parameters and menu selection
Press and hold the
-key to open the user menu. Turn the
left control knob until the desired menu is displayed. Use
the right control knob to alter settings displayed in the right
display. Press the
-key briefly to activate functions, such as
gas test.
Functions and parameters in the user menu:
Press the
-key to exit the menu
GAS test
Press the
-key to open and close the gas valve. If
an IGC kit is installed, it is possible to adjust the gas flow with
the right control knob.
IGC calibration
Visible only if IGC kit is installed.
Press the
-key to start IGC calibration.
Water cooling
Visible only if water cooling unit is installed.
0: Water cooling ON
1: Water cooling OFF
Setting remote control
Use the right control knob to change the following
settings:
0: Disabled
1: Dialog torch (item no. 80100402)
2: Analogue remote control (item no. 78815029)
22
2. Find menu selection
5 secs
5. Save selected data
3. Select menu point
Exit menu
Gas test
IGC calibration
(not all models)
Water cooling
Remote control
6. Exit menu

Publicidad

Tabla de contenido
loading

Tabla de contenido