Error Handling; Error Log - Migatronic SIGMA SELECT 300 Guía De Usuario

GRAPHICAL - Special functions
Calibration of gas flow (not all models)
I
IV
L
10
=
min
L
20
=
min

Error handling

SIGMA Select has a sophisticated built-in self-protection system. The machine automatically stops the gas supply, interrupts the welding
current and stops the wire feeding in case of an error.
Selected errors:
Torch cooling fault
Cooling fault is indicated on machines in case of insufficiant circulation of the cooling liquid due to faulty connection, defective parts or
choking. Check that the cooling hoses are correctly connected, top up the water tank and check welding hose and branches.
The cooling fault is cancelled by pressing shortly on the
Gas control fault (IGC)
Gas fault exists due to a to low or high gas flow.
Make sure that the pressure on the gas flow is higher than 2 bar and less than 6 bar, corresponding to 5 l/min and 27 l/min.
The fault is disconnected by adjusting the manual gas flow to 27 l/min. The gas fault is reset by a short pressure on the

Error log

I
28
II
V
L
10
min
L
20
min
2
P
II
1
-key pad.
III
Error log
All errors are saved in the
machine error log in the
menu Service. The error log
can be distributed, when
inserting a SD-card and
pressing the following key:
The error log is now saved
at the SD-card.
The error log can be reset
when pressing the key pad
with the trash bin.
III
P
-key pad.