SICK LGT 015 Instrucciones De Operación página 200

Operating instructions
LGT
200
8 007 557/S711/2008-06-04 © SICK AG • Safety Systems • Germany • All rights reserved
Technical data
Contamination
Response time
Length of the connecting
cables )
3
Clamping area of the
connecting terminals
Operating data
Safety category
Requirements
Ambient operating
temperature
Air humidity
(non-condensing)
Storage temperature
Dimensions
Housing colour
Vibration performance
Shock resistance
) A power supply with safe isolation (SELV, PELV circuit) is to be used
1
) The ripple must not cause the voltage to exceed or pass below the limits.
2
Attention: in case of high energy voltage transients between the DC supply
and the PE potentia (≥ 0,5 kV) a change to an AC supply and/or insulated
installation of the sensor rails is recommended. In case of malfunction, the
sensor wires are to be laid separately from the cable channel emitting
interference.
3 ) Cannot be shortened
Primary relay
min. typ.
Short-circuit protected
U – 2,5 V
V
(HIGH)
2.5 m
0.1 mm
2
Type 2 (testable)
pr EN 50100
– 10 °C
15 %
– 25 °C
See Section 10 Dimensional drawings
Cadmium yellow, RAL 10-21
5 g, 10 ... 55 Hz in accordance with
IEC 68-2-6
10 g, 16 ms in accordance with
IEC 68-2-29
Auxiliary relay
Chapter 9
m a x .
100 mA
U
V
600 μA
(I )
Q
50 ms
10 m
1.5 mm
2
+ 55 °C
95 %
+ 70 °C