Eaton Powerware 9125 Guia De Instalacion página 36

INSTALLATION
Figure 23. Connecting Server/Device with One Power Cord (Non-Redundant) to UPS
Mains
Figure 24. Connecting Server/Device with Two Power Cords (Dual-Redundant) to UPS
Figure 25. Connecting Server/Device with Two Power Cords (Redundant) to UPS
1.
NOTE The redundant power source must be protected with Transient Voltage Surge
Suppression (TVSS).
22
EATON Powerware
UPS
1
Mains
Server/Device
UPS
2
1
UPS
1
Mains
UPS Only: If you are installing a UPS and non-redundant power to
the device(s) is desired, plug the PDU power cord into the UPS
output receptacle (see Figure 28 or Figure 30) using the supplied
power cord.
If you are installing a UPS and dual-redundant power to the
device(s) is desired, two PDUs are required. Plug the first PDU
power cord into the UPS output receptacle (see Figure 29 or
Figure 31) using the supplied power cord. Then plug the second
(redundant) PDU power cord into a non-UPS protected output
receptacle (mains) or into a second UPS.
®
9125 (9910-P64) UPS Installation Guide for IBM
Server/Device
2
TVSS Protected or
Second UPS
3
Mains
Server/Device
2
® S
Applications 164201637 Rev A