Changing The Batteries - Arregui RESIST Manual De Instrucciones

C.4. DELETING USER CODE ( with master-code)
• Press the * key + ENTER
• Press the 0 key + ENTER
• Enter the valid master-code and press ENTER
• The user code is deleted.
If the new code is entered correctly, 2 beeps souds and a green LED
flashes. Otherwise, 3 beeps sound warning that the operation was
not succesfull, so the initial code remains saved. Repeat again the
operation.
During operation if you enter a wrong number of digits, a red LED
flashes warning about the error. After an error is made, start the
programming again by pressing ENTER or the * key.
D. CHANGING THE BATTERIES
If the voltage is low, every time "*" key is pressed 5 beeps sounds and
the red LED flashes warning the batteries have to be changed.
Extract the battery compartment located outside the safe, at the lower
part of the keyboard, and place 4 alkaline batteries of 1.5 V. The code
remains saved even if the battery is switched off.
<EN>