RIB T2 Manual Del Usuario página 25

OPTIONALS -
R
ADIO TRANSMITTER MOON
ACG6082 - MOON 433
ACG7026 - MOON 91
C
ODE LEARNIG SYSTEM RADIORECEIVERS
RX91/A quarzata and coupling
RX91/A quarzata and terminal board
RX433/A super eterodyne and coupling
RX433/A super eterodyne and terminal board
RX433/A 2CH super eterodyne, 2 channel and coupling code ACG5051
RX433/A 2CH super eterodyne, 2 channel and terminal board
S
PARK
In order to make the systems mentioned above give the best
performances, you need to install an aerial, tuned on the frequency of
the radio receiver installed.
PAY ATTENTION: to not let the central wire of the aerial cable to get in
short circuit with the external copper shield, since this would prevent
the aerial from working.
Install the aerial vertically and in such a way the remote control can
reach it.
SPARK ANTENNA 91
SPARK ANTENNA 433
SPARK BLINKER WITH IN-BUILT INTERMITTENT CARD
For the connections and the technical data of the fixtures follow the relevant handbooks.
ACG6081 - MOON 433
ACG7025 - MOON 91
code ACG5005
code ACG5004
code ACG5055
code ACG5056
code ACG5052
code ACG5454
code ACG5452
code ACG7059
F
IT SLIM
PHOTOCELLS for the wall-installation
FIT SLIM photocells have synchronism function in AC current and
ranges of 20 m.
You can fit many photocell couples close together thanks to the optional
synchronizing circuit SYNCRO TRANSMITTER TX SLIM SYNCRO
code ACG8029 for more than 2 photocells couples (up to 4).
B
LOCK
KEY SELECTOR FOR WALL-INSTALLATION
KEY SELECTOR TO BUILD-IN
H
EATER ONLY FOR KING ICE
The in-built thermal sensor of the KING ICE motor can be connected to
the terminal block J7 on the T2 control board. For the connection details
please refer to the KING ICE Instruction Manual.
The probe for motor heating is a device intended to be used in
extremely cold environment (up to -30°C) to avoid motor freezing.
Such device activates automatically when the gate is steady (the
position being irrelevant, provided it is not moving).
The work of the heater is indicated by both the DL6 and DL7 leds
for the motor number 1, and by the DL4 and DL5 leds for the motor
number 2.
When the motor is running the heating system is inoperative.
On elapsing of 10 seconds delay from gate stop, the heating system
gets activated (in case the environment temperature in the motor area
is below 20°C).
Upon achieving a 30°C temperature the heating system deactivates,
maintaining a constant environment temperature.
TECHNICAL DATA
Cable lenght 45 cm
Resistance 10K ±2% (at 25°C)
Working temperature -30 ÷ +55°C
G G
B B
code ACG8032
code ACG1053
code ACG1048