Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE MACHINE START-UP
STARTING AND STOPPING THE MACHINE
Checklist
Cleaning planning
Filling the DustGuard™ system water tank (optional)
Starting the machine
09/2016
1.
Have a full knowledge of the machine operating controls and their functions.
2.
Insert the key (51) and start the machine (see the procedure in the following paragraph).
3.
batteries set (71-B) and the current maximum machine speed setting (71-C).
4.
Check the fuel reserve icon (71-P); if it is lit, range will be limited. Replace the LPG tank (see previous paragraph).
5.
Check the horn with switch (65), the reverse gear buzzer with switch (64) and the working light switch (67, optional) for proper
operation.
6.
all defects immediately to Advance Service Center).
7.
Check the service brake pedal (6) for proper operation.
WARNING!
(report all defects immediately to Advance Service Center).
8.
Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
1.
Arrange long runs with a minimum of stopping or starting.
2.
Allow a small amount of broom path overlap to ensure complete coverage.
3.
Avoid making sharp turns, bumping or scraping the side of the machine.
1.
2.
1.
Sit on the driver's seat (3) and adjust it with the lever (4) to allow easy reach of all controls.
NOTE
The driver's seat (3) is equipped with a safety sensor, which allows the machine to be driven only when the operator is
on the driver's seat.
2.
Turn the ignition key (51) clockwise to the "I" position.
3.
Wait for the multifunction display to show the work screen (71-D).
4.
Turn the ignition key (51) to the start position "II", then release it when the engine starts.
5.
After starting, let the engine idle for a few seconds.
CAUTION!
When starting do not press the accelerator pedal (5).
6.
Disengage the parking brake.
7.
Drive the machine to the working area, maneuvering it by turning the steering wheel with your hands (1) and pressing the
accelerator pedal (5).
The speed can be adjusted by applying more or less pressure to the accelerator pedal (5).
The maximum running speed can be set with push-buttons (58) and (59).
8.
The forward/reverse direction is selected with the relevant push-button (64) on the dashboard. Activation of reverse gear is
indicated by the buzzer and on the display (71-H).
WARNING!
When steering, avoid abrupt direction changes, pay careful attention and drive the machine at slow speed,
especially when the hopper is full or when operating on inclines.
inclines.
Do not turn the machine on an incline; drive straight up or down.
NOTE
The machine has an anti-skid safety system, which where necessary reduces speed when steering and when the
machine is driving on a camber, regardless of the pressure applied to the pedal.
This reduction in speed is therefore not a malfunction but a characteristic which increases the stability and safety of the
machine in all conditions.
In the first 2 seconds after turning on, the multifunction display (71) shows the machine working hours (71-A), the type of
Check the parking brake (7 and 6). The brake must hold its (locked parked) setting firmly without easily being released (report
If the pedal is "spongy" or fades under pressure without an efficient braking force, do not drive the machine
Remove the plug (25) to reach the filler neck.
Fill the tank (24) with clean water. Do not fill the tank completely, leave a few centimeters from the edge.
Drive the machine slowly on inclines. Use the brake pedal (6) to control machine speed while descending
INSTRUCTIONS FOR USE
1467287000 - SW5500
ENGLISH
17
Publicidad
Tabla de contenido
