Publicidad
VIEWING IMAGES ON YOUR PLASMA DISPLAY
VISUALISATION DES IMAGES SUR L'ECRAN A PLASMA
BILDWIEDERGABE AUF IHREM PLASMA-DISPLAY
RS-232C
2, 4
1
2
Main unit
Unité principale
Hauptgerät
Remote control
Commande à distance
STANDBY
Fernbedienung
STANDBY/ON
3
Remote control
Commande à distance
Fernbedienung
RGB 1
Main unit
Unité principale
Hauptgerät
INPUT
4
Main unit
Remote control
1
Unité principale
Commande à distance
Hauptgerät
Fernbedienung
STANDBY
STANDBY/ON
2
STANDBY
/ON
12
<ARE1356>
En/Fr/Ge
2, 4
STANDBY
/ON
3
INPUT
MENU
ADJUST
SET
1, 4
3
STANDBY
/ON
STANDBY
/ON
/ON
RGB 1
STANDBY
/ON
/ON
1
Input the power to the main unit.
The standby indicator will flash in red for about 4
seconds. The display then enters standby state and
the indicator remains lit.
NOTE:
The buttons on the main unit and remote control unit,
and the external control commands are not accepted
by the display unit while the standby indicator is flash-
ing in red.
If the optional video card (PDA-4004) is not installed
properly, the STANDBY indicator blinks as described
below to inform the use of abnormality.
• Blinking twice
Only the terminals are installed:
Install the video card.
• Blinking three times
Only the video card is installed:
Install the terminals.
2
Turn on the Display.
The STANDBY indicator turns green.
3
Select an input source.
• Press the INPUT button on the main unit. Each time
press changes the input source as follows:
RGB 1
RGB 2
• To choose an input source with the remote con-
trol, press the INPUT SELECT button.
• The function cannot be switched at the MENU
screen.
"NO SYNC!" is displayed if no signal is being input .
"OUT OF RANGE!" is displayed if the signal being
input cannot be processed on this set.
4
After use, turn off the power.
1 Turn off the power.
The standby indicator flashes in red for about 4 sec-
onds, then remains lit (standby state).
2 Turn off the MAIN POWER switch on the main
unit.
The STANDBY/ON indicator will dim and the power
to the unit will be turned off.
NOTES:
• The buttons on the main unit and remote control
unit, and the external control commands are not ac-
cepted by the display while the standby indicator is
flashing in red.
• Do not display the same image (still images, etc.)
for a long time as the image may stick onto the
screen.
Publicidad
Capítulos
