Camp Safety SHOCK ABSORBER Manual Del Usuario página 29

use connectors with defective operation.
If an operational defect appears, clean and lubricate the mechanism with a silicon based lubricant. Clean
and lubricate are recommended after each use in marine environments. If, after oiling, the defect persists,
the carabiner has to be put out of use
REVISION
inspection required before, during and after each use, this product must be inspected by a skilled person every 12
: keep this literature for inspection and reference for the life of the device. Check the legibility of
In case of one of the following defects are present, the product should be withdrawn from service immediately:
• cuts and/or burns on the webbings/ropes
• cuts and/or burns on the stitching
• partial or total extension of the energy absorber
• deep corrosion that seriously alters the surface state of the metal (which does not disappear after a light rubbing
with emery paper)
• play or exit of the rivet from the gate of the carabiner
• incorrect placement of the gate on the carabiner body
• play or exit of the rotation axis of the gate
•
1mm
• presence of cracks particularly on the rotation axis of the gate
•
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service immediately.
Each product in the safety system can be damaged during a fall and must be always inspected before use it again.
Do not continue to use a product after a major fall because a damage may have occurred, even no external signs
are visible.
LIFETIME
The lifetime is understood to be in the absence of causes which would place the product out of order with the
condition that periodic inspections are carried out at least once every 12 months starting from the date the product is
The following factors can reduce the lifetime of the product: intense use, damage to components of the product,
contact with chemical substances, high temperatures, tears and abrasions, violent impacts, failure to maintain as
recommended. If a product is suspected to be no longer safe and reliable, replace the product or contact C.A.M.P.
or the distributor before continuing use.
Shock absorber:
consideration) in any case cannot exceed the end of the twelfth year from manufacturing (i.e. manufacture year 2020,
Carabiners: The lifetime of the product is unlimited
TRANSPORTATION Protect the product from risks such as those detailed above.
Attention: each lanyard with absorber is supplied with a marking on the lanyard for reference identifying the product
as a whole, and a marking on the absorber to identify only this part.