Philips HeartStart MRx Manual Del Usuario página 2

Wireless Link
Connecting Wireless Link
Once your Wireless Link, HeartStart MRx and receiving computer have been set-up and configured
properly to send data to the appropriate destinations, you need to connect the Wireless Link to the
HeartStart MRx.

To connect the Wireless Link to the HeartStart MRx:
Depending on your carry case, place the Wireless Link device in the carry case as shown in Figure 1.
1
There are two recommended locations:
•
•
Figure 1
Place Wireless Link as shown in the meshed bag
along the back of the back pouch. Thread the
connectors through the larger of the two holes
to the HeartStart MRx.
Red Carry Case - therapy side pouch
CAUTION: Placing the Wireless Link in positions other than the ones shown in Figure 1 may
2
in the back pouch
in the therapy side pouch
Recommended Wireless Link Placement
Black Soft Carry Bag - back pouch
Place Wireless Link as shown in the therapy side
pouch. Rest it on the bottom of the bag. Thread
cable along bag wall, behind dividers, through
the opening to the HeartStart MRx.
result in diminished signal strength.
Black Soft Carry Bag -
Therapy side pouch with elastic band
Place Wireless Link face down as shown in elastic
band on the therapy side pouch wall. Thread cable
along bag bottom, through the bottom opening
and connect to the HeartStart MRx.
Black Soft Carry Bag -
Therapy side pouch without elastic band
Rest the Wireless Link on the bottom of the far
outside pouch, facing out. Thread cable along bag
bottom, then up through the Therapy port
opening and connect to the HeartStart MRx.