Philips HeartStart MRx Manual Del Usuario página 3

2 With the HeartStart MRx off, plug the RS-232 serial connector into the RS-232 serial port on the
back of the HeartStart MRx. Confirm the plastic stabilizer is in place and screw in the pins. See
Figure 2.
Plug the LAN cable into the LAN port on the back of the HeartStart MRx. See Figure 2. You can
3
now turn the HeartStart MRx on and use the Wireless Link Option.
Figure 2
CAUTION: To test your ability to successfully transmit before using in a clinical situation, you must create sample
data and send it to a live Telemedicine System or Data Messenger. Be sure to delete the data from your
Telemedicine System or Data Messenger after the test is complete so as to not confuse it with real patient
data.
Sending Data with Wireless Link
You can use Wireless Link to send data during patient care or post-event. During an event, you can send
12-Leads or periodic clinical data (PCDT). Post-event transmissions include Event Summaries. For more
information on sending data, see the Data Transmission chapter in the HeartStart MRx Instructions for
Use.
NOTES: Assuming Wireless Link is connected when the HeartStart MRx is first powered on, it typically takes
approximately 90 seconds for Wireless Link to be ready to send data. Different IT environments and
configurations can take longer. If you initiate a 12-Lead transmission in a clinical mode before Wireless
Link is ready, the HeartStart MRx automatically retries to send data in 30 seconds.
Successful transmission is dependent on the availability of public or private telecommunication networks
and other influencing factors, particularly for cellular communications. These factors include but are not
limited to weather, geography, your transmitting location, cellular service availability, the number of
cellular service users in the area, and your authorization/subscription from the cellular service provider.
Data transmission via the telecommunication networks cannot be assured with the use of such networks.
Make sure you have a contingency plan for interrupted or unsuccessful data transmissions.
The steps to send data from the HeartStart MRx are the same regardless if data is being sent via WiFi or
cellular broadband communication.

To send the current 12-Lead from 12-Lead Mode during an event:
1 In 12-Lead Mode, press the Menu Select
2 Using the Navigation buttons, select
3 Using the Navigation buttons, select the pre-configured destination for the 12-Lead and press the
Menu Select button. Transmission begins.
Connecting Wireless Link
button.

and press the Menu Select button.
Wireless Link
3