Lubrication; Spare Parts - ITALVIBRAS GIORGIO SILINGARDI CDX gr.110 Guia Tecnica

ENGLISH

5.1 LUBRICATION

All bearings are correctly lubricated on mounting the vibrator.
All ITALVIBRAS vibrators are realised to use the "FOR LIFE",
lubrication system and therefore do not require periodical
lubrication.
Only for heavy duty, as for example 24 hour service with high envi-
ronmental temperatures, periodical re-lubrication of the bearings is
recommended, using the two external greasers (1/8" NPT) with the
following type of grease:
- KLUEBER ISOFLEX TOPAS NB 52.
Failure to use grease type Klueber Isoflex Topas NB 52 shall void
the guarantee with which the motor-driven vibrator is covered.
Use of a different grease could damage the electric vibrator.
Approximately, on average, the frequency of re-lubrication can be
included between 1000 and 5000 hours and depends on the operative
conditions and the type of vibrator, therefore it can be lower or higher
than the indicated values. The quantity of grease to be introduced on
periodical lubrication is indicated in the table on page 81.
It is advised to contact ITALVIBRAS for particular uses which is at
complete disposal to advise the client on the best lubrication possible
for the specific use.
Never mix greases even if they have similar features. Excessive
quantity of grease causes increased heating of the bearings and
consequent anomalous current absorption.
Respect the ecological laws in force in the country in which the
equipment is used, relative to use and disposal of products used
for cleaning and maintenance of the vibrator. Always comply with
recommendations of the manufacturer of these products.
If the machine must be demolished, comply with the anti-pollu-
tion regulations envisioned in the country of use.
Remember that the Manufacturer is always available for any
type of assistance and spare parts.

5.2 SPARE PARTS

On requesting spare parts always state:
- Type of vibrator (TYPE detectable from the identification plate).
- Serial number (SERIAL NO. detectable from the identification
plate).
- Power supply voltage and frequency (VOLT and HZ detectable
from the identification plate).
- Spare part number (detectable from the spare part table starting
from page 82) and desired quantity.
- Exact destination address of the goods and means of delive-
ry.
ITALVIBRAS declines any liability for incorrect forwarding due
to incomplete or confused requests.
ITALVIBRAS declines any liability for maintenance operations
carried out by a third part company, even if usingoriginal spare
parts.
1
ENGLISH