Publicidad
en_us | 45 | T50057
3 Operating Instructions
1.
Check the lifting device for completeness, as well
as visible damages such as signs of wear,
deformation, breakages, cracks, thread, and
corrosion damage prior to each use. Check the
condition and screw connection of the ring bolt
and the support. Do not use the lifting device when
defects are noted and discard it immediately.
2.
Carry out the necessary preparation work for the
use of the lifting device in accordance with the
workshop manuals.
3.
Align the lifting device in such a manner that the
sleeve can be plugged into the base plate of
T50057 on the switching shaft.
4.
Fasten the lifting device to the counter shaft with
the knurled screw. Screw in the knurled screw until
it comes to a stop.
5.
Suspend the lifting device on the workshop crane
with the additional hook 10-222A/2.
2018-05-08
WARNING
Risk through falling load!
Incorrect attachment of the lifting device may cause the
load to fall. This could cause serious personal injury or
severe damage to materials.
Attach the lifting device exactly as described in the
workshop manual.
Screw the knurled screw into the counter shaft until
it comes to a stop.
CAUTION
Incorrect attachment of the lifting device can cause
damage to the shafts!
This could cause severe damage to materials.
Attach the lifting device exactly as described in the
workshop manual.
Only use the original knurled screw and sleeve
supplied.
6.
Carry out further work as described in the
workshop manuals.
7.
Ensure that all parts of the special tool have been
removed after completing the repair work.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany
Publicidad
Capítulos
