SPALDING M6A40201 Manual Del Usuario página 15

4.
While maintaining alignment of dimple and trough, bounce top and middle pole
assembly (4 and 5) onto bottom pole section (6) using a wood scrap as shown.
Bounce until the top and middle pole assembly (4 and 5) is aligned with the
marked line on the bottom pole (6).
You should have a 3 1/2" (8,9 cm) of overlap when properly assembled.
CAUTION!
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 3-1/2" (8,9 CM)
OVERLAP.
IMPORTANT!
Align dimple of middle pole section (5) into
trough of bottom pole section (6) as shown.
5
MIDDLE POLE
DIMPLE
TROUGH
MARKED LINE
6
BOTTOM POLE
HOLE
(NOT USED
IN ASSEMBLY)
MARK LINE
3 1/2"
(8,9 cm)
15
4
TOP POLE
5
MIDDLE POLE
6
BOTTOM POLE
Wood Scrap
(not supplied)