Height Adjustment - SPALDING M6A40201 Manual Del Usuario

REQUIRED TOOLS
AND MATERIALS:
• 2 Capable Adults
• Tape Measure
• Wood Board
(scrap)
• Sawhorse or
Support Table
• Hammer/Mallet
• Safety Glasses
• Step Ladder - 8ft.
(2.4 m)
• Phillips-Head
Screwdriver
• (2 each) Wrenches and/or Socket
Wrenches and Sockets (Deep-
Well Sockets are Recommended).
1/2" 9/16" 3/4"
AND/OR
1/2" 9/16" 3/4"
• Extension is Recommended.
• Garden Hose or Sand
OPTIONAL TOOLS
AND MATERIALS:
•
Large and Small Adjustable
Wrenches

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:
1. While holding handle, remove pin.
2. Move elevator up or down to
desired height.
3. Replace pin full length to lock
system at desired height.
MOVING SYSTEM
1. Adjust basketball backboard
height to lowest position.
1
2. While holding pole, rotate
basketball system forward
until wheels engage with
ground.
3. Move basketball system to
desired location.
2
4. Carefully rotate basketball
3
system upright.
4
5. Check system for stability.
3
1
3
Owner must ensure that all players know and follow these rules
• DO NOT hang on the rim or any part of the system including
2
backboard, support braces, or net.
• During play, especially when performing dunk type activities, use
caution to keep face away from the backboard, rim, and net.
Serious injury could occur if teeth/face come in contact with
backboard, rim, or net.
• DO NOT slide, climb, shake, or play on base and/or pole.
2
• After full assembly, fill system completely with water or sand.
Never leave system in an upright position without filling base with
weight, as system may tip over, causing injuries and/or property
damage.
• DO NOT add ballast on top of base (such as sand bags or cinder
blocks). Such added ballast can crack base, causing leakage,
which could cause system to tip over. DO NOT use ballast on top
of base as substitute for filling base with water or sand.
• When adjusting height or moving system, keep hands and fingers
away from moving parts.
• DO NOT allow children to move or adjust system.
• DO NOT wear jewelry during play (rings, watches, necklaces, etc.).
Objects may entangle in net.
• Surface beneath the base must be smooth and free of gravel or
other sharp objects. Punctures or cracks in base could result,
causing leakage which could cause system to tip over.
• Keep organic material and water away from pole base. Grass,
water, litter, etc. could cause corrosion and/or deterioration.
• Keep pole top covered with cap at all times. Water and debris
entering pole through uncapped top can cause corrosion from
the inside.
• CHECK pole system for signs of corrosion (rust, pitting, chipping)
and repaint with exterior enamel paint. If rust has penetrated
through the steel anywhere, replace pole immediately.
• CHECK system before each use for proper ballast, loose
511679 05/05
hardware, excessive wear, and signs of corrosion; replace or
repair before use.
• CHECK system before each use for instability.
• DO NOT use or leave system upright during windy and/or adverse
weather conditions; system may tip over. Place system in the
storage position and/or in an area protected from the wind and
weather, and free from personal property and/or overhead wires.
• Never play on damaged equipment.
• See instruction manual for proper assembly and maintenance.
• When moving system, use caution to keep height adjust
mechanism from shifting.
• Do not allow water in tank to freeze. During sub-freezing weather
add at least 2 gallons of non-toxic antifreeze or sand, or empty
tank completely and store. (Do not use salt.)
• DO NOT allow anyone to stand or sit on base while moving system.
• DO NOT leave system unsupervised, or play on system when
wheels are engaged for moving.
• Use caution when moving system across uneven surfaces.
System may tip over.
• Use extreme caution if placing system on sloped surface. System
may tip over.
WARNING
Size = 4" x 5.5"
READ AND UNDERSTAND WARNINGS
LISTED BELOW BEFORE USING THIS
PRODUCT.
Corner Radius = 3/8"
FAILURE TO FOLLOW THESE WARNINGS
MAY RESULT IN SERIOUS INJURY AND/OR
Die Cut Label
PROPERTY DAMAGE.
3.25 Mil Vinyl
for safe operation of the system.
All Temp. Permanent Adhesive
1 Mil. Polypropolyne Overlaminate
Illustrator 8.0 = EPS
Backing + 1/16 Circumference
Rolls of 500
EXACTA-HEIGHT : ADJUSTMENT
PORTABLE
511679
Trademarks registered
in the USA and other countries.
In the U.S.: 1-800-558-5234
ID#: 500082 07/21
In Canada: 1-800-284-8339
In Australia: 1-300-367-582