Whittier Wood Products 232W Instrucciones De Montaje página 9

232W x 2
P
x3 drawers
243W x 1
232W x 2
O
x3 drawers
243W x 1
FIG. 16
16. Attach a Drawer Face (M) to the Drawer False Front (J). Insert Screws (O) through the center
holes in the Drawer False Front (J) and LOOSELY fasten the Knobs (P). There are two knobs
per drawer on the 232W and one knob per drawer on the 243W. See FIGURE 16. DO NOT
INSERT SCREWS (Q) AT THIS TIME.
Repeat the above steps with the other Drawer Faces (M).
x3 drawers
Q
x 4
FIG. 17A
17. Install bottom drawer in the unit. To do so, tilt the drawer down slightly and place the wheels on
the drawer slides into the cabinet side slides. Raise until level and push in. Make sure that the
Knobs (P) are loose to allow the Drawer Face to move freely on the Drawer False Front (J).
Adjust the Drawer Face (M) on the Drawer False Front (J) so that it is centered side to side.
Repeat with the other two drawers making sure there is a small gap between the drawers and
top, bottom and sides of the shelf compartment. As you get each drawer in place, tighten the
Knob (P) to help eliminate any shifting of the face. Once all the drawers are in position, insert
four Screws (Q) through the holes in the Drawer False Front (J) and fasten securely. See
FIGURE 17. Repeat for each drawer.
18. When you have determined the location of your base unit, install the Furniture Tipping Restraint
that came with the unit.
P
O
O
P
Note: The 243W Drawer has
only one knob per drawer.
Q
Q
FIG. 17B
232W/243W — Page 9