Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
revised 03/2018
MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
If necessary, adjust the solution quantity by pressing the push-buttons (59 and 60).
3.
If necessary, to reduce the noise, turn on the mute function by pressing the push-button (55).
NOTE
It is suggested to use the mute function only on smooth floors without joints.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in figure 2.
A
A
Squeegee adjustment
4.
If necessary, stop the machine and turn the squeegee balance adjusting handwheel (35) so that the rear blade - in all its length
- touches the floor.
Adjustment of the detergent concentration in the solution
The system used to mix the detergent with the washing water can be activated by pressing the detergent flow control push-button
(A, Fig. 3): when the LED (B) is on, the detergent is added to the washing water.
The display (C) shows the detergent concentration level in the solution as shown in the table in Figure 3.
NOTE
The detergent concentration in the solution dispensed from the system always corresponds to level 1. In order to
temporarily obtain a stronger concentration, press the EcoFlex or disable the EcoFlex system (see the relevant
paragraph).
EcoFlex function
Lift the EcoFlex lever (D, Fig. 3) whenever a stronger washing power is required.
When lifting the lever (D) (LED (E) flashing) the solution flow increases, the extra pressure function activates and the detergent
concentration in the corresponding solution rises to the set level (moreover, if the detergent mixing function is not activated, it
activates automatically).
The original settings can be restored by lifting the lever (D) once again (LED (E) on).
NOTE
If the lever (D) is not lifted once again, the original settings are restored automatically after 60 seconds.
In order to change the actual detergent concentration, proceed as follows:
1.
Turn off the detergent flow control push-button (A) (the LED (B) must be OFF).
2.
Press and hold the detergent flow control push-button (A) until the LED (B) flashes.
3.
Release the push-button (A). Press it again shortly to go to the next level shown by the display (C) as shown in the table in
Figure 3; repeat the procedure until the desired setting is reached.
4.
Wait until the LED (B) stops flashing: the new level is now set.
NOTE
Detergent percentage setting is stored into memory, even if the machine is turned off.
10/2010
INSTRUCTIONS FOR USE
B
Figure 2
9098827000 - SC3000 26 D
ENGLISH
P100364
17
Publicidad
Tabla de contenido
