Preparing The Machine For Use; Before Each Use - Nilfisk Advance Proterra Instrucciones De Uso

PREPARING THE MACHINE FOR USE

BATTERY CHECK/SETTING ON A NEW MACHINE
PRE-OPERATIONAL CHECKLIST
revised 08/2018

Before Each Use:

In the driver's seat:
09/2010
WARNING!
–
–
–
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see Visible Symbols On
The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if they are damaged.
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires 48 V batteries, in serial connection.
a) Batteries already installed and ready to be used (optional)
b) Without batteries
a) Batteries already installed and ready to be used (optional)
1. Open the battery compartment hood (1) by using the unlocking push-button (25).
2. Check that the batteries are connected to the machine with the connector (40).
3. Carefully close the hood.
4.
Maintenance chapter).
b) Without batteries
1. Buy appropriate batteries (see Technical Data paragraph).
2. Install the batteries (see the procedure in Maintenance chapter).
3. Perform a complete charging cycle of the batteries (see procedure in the Maintenance chapter).
1. Check the machine for damage or oil leaks.
2. Check the hydraulic system oil level (19) (see the relevant paragraph).
3. Insert the ignition key (57) and turn it to "I", then check the battery warning lights (51):
• If all LEDs (51) turn on, the batteries are charged.
• If some yellow LEDs turn on, or the red LED turns on, the batteries must be charged (see the procedure in Maintenance
chapter).
4. Be sure to understand the operating controls and their functions.
5. Adjust the seat with the lever (41) to allow easy reach of all controls.
6. Adjust the steering wheel height with the lever (62) in order to reach a comfortable position.
7. Insert the ignition key (57) and turn it to "I":
• Check the horn (58), hour counter (56) and headlights (61, optional) for proper operation.
• Turn the ignition key (57) to "O".
8.
(report all defects immediately to service personnel).
9. Check the service brake pedal (6) for proper operation.
WARNING!
10. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
or connected. The batteries must be installed by qualified personnel only.
Check the batteries for damage before installation.
The machine can be supplied in one of the following configurations:
According to machine configuration, proceed as follows.
On first use of the machine with new batteries, perform a complete charging cycle of the batteries (see procedure in the
For battery choice and installation, apply to qualified battery Retailers.
Check the parking brake (35 and 36). The brake must hold its (locked parked) setting firmly without easily being released
If the pedal is "spongy" or fades under pressure without an efficient braking force, do not drive the machine
(report all defects immediately to Advance Service Center).
INSTRUCTIONS FOR USE
33019867 - Proterra™
ENGLISH
15