Transmitter Wiring - Siemens SITRANS F FUS1010 IP65 NEMA 4X Instrucciones De Servicio

3.2

Transmitter Wiring

Connecting Power
Electrical Shock Hazard
Contact with exposed wiring will lead to fire, electric shock, or serious personal injury.
Turn off main power before installing AC connections to the transmitter.
Note
If the transmitter is not already mounted and cabling has not been run, proceed to Mounting
the Transmitter (Page 15) before connecting power.
1. Open the transmitter top cover by releasing the cover latch (for IP66 NEMA 7, remove
2. Unscrew the two power supply access cover fasteners and remove access cover.
3. Locate power supply connector J10. Using a flat blade screwdriver, remove plug from
FUS1010 IP65 NEMA 4X & IP66 NEMA 7 Quick Start
Operating Instructions, 01/2013, A5E03086486-AC
WARNING
Electrical Voltage Hazard
Incorrect device connections may result in death or severe personal injury and/or
equipment and property damage.
Only commission the device after the device has been properly connected and, if
required, closed.
DANGER
bolts).
connector J10. Set aside.
Connecting
3.2 Transmitter Wiring
21