Installing The Sensor - Siemens SITRANS F FUS1010 IP65 NEMA 4X Instrucciones De Servicio

Connecting
3.5 Sensor Installation

Installing the Sensor

1. Take either sensor and apply a continuous lengthwise 3mm (1/8-inch) bead of coupling
42
compound across the center of the sensor emitting surface.
①
F-Connector
②
Angled Edge
③
Sensor
Figure 3-9 Sensor
①
Front View
②
Spring Clip (Not present on some
models)
③
Sensor Clamping Screw
④
Spacer Bar
⑤
7ME39600M Mounting Frame
Figure 3-10 Sensor Installation
④
Front Face
⑤
Emitting Surface
⑥
Coupling Compound
⑥
Pipe
⑦
Mounting Strap Note: Optional 2nd
Mounting Strap shown. Larger pipes over
76cm (30 inches) may need an additional
support.
⑧
Spacer Bar Platform and Clamping
Screw
⑨
Spacer Bar Reference Hole
⑩
Orientation for Single Beam Sensor at 9
o'clock position
⑪
Orientation for Dual Beam Sensor at 10
& 2 o'clock positions
FUS1010 IP65 NEMA 4X & IP66 NEMA 7 Quick Start
Operating Instructions, 01/2013, A5E03086486-AC