Preparing The Pipe - Siemens SITRANS F FUS1010 IP65 NEMA 4X Instrucciones De Servicio

Connecting
3.5 Sensor Installation
Before beginning refer to the Reflect Mount Installation diagram example below.
①
②
③
④
Figure 3-8
Note
Minimum Ltn 18 mm (0.75 in).
Ltn Menu Cell
This view only menu cell shows the distance in inches or millimeters between the front faces
of the sensors along the axis of the pipe. If you are mounting the sensors without a track or
spacer bar, you have to space them according to this value. Note that Ltn may be a negative
number for direct mount on very small pipes where the sensor spacing overlaps.

Preparing the Pipe

1. On a flat surface, attach the Spacer Bar to a Mounting Frame so that the Reference Hole
2. Slide the second Mounting Frame onto the other end of the Spacer Bar and align the
40
Optional: On larger pipes, multiple lengths
of straps can be linked together to
surround pipe
Mounting Strap positioned around
Mounting Frame
Sensor shown in the 9 o'clock position on
pipe
Mounting Frame
Reflect Mount with Mounting Frames and Spacer Bar
on the Spacer Bar fits over the metal post on the platform of the frame. Tighten the
clamping screw.
Number Index Hole with the metal post on the platform. Then tighten the clamping screw.
Ensure that the angled sides of both frames face away from each other.
⑤
Space Bar Platform & Clamping Screw
⑥
Space Bar (Front View)
⑦
Metal Post
⑧
Mounting Strap Adjusting Screw
FUS1010 IP65 NEMA 4X & IP66 NEMA 7 Quick Start
Operating Instructions, 01/2013, A5E03086486-AC