Kettler Marathon TX2 Manual Del Usuario página 14

All manuals and user guides at all-guides.com
GB
Training directions
session, you should continue to run slowly for about 2 – 3 minutes.
The load for your further endurance training should generally
be increased first by the extent of the load, e.g. instead of 10
minutes daily, do 20 minutes or instead of once weekly, train
twice or three times a week. Beside the individual planning of
your endurance training, you can fall back on the training pro-
grams integrated into the training computer on the treadmill.
You can determine whether your training has achieved the des-
ired result after some weeks as follows:
1. You manage a certain endurance level at lower cardiovascu-
lar performance than before.
2. You maintain a certain endurance level with the same cardio-
vascular performance over a long time.
3. You recover more quickly from a certain cardiovascular per-
formance level than before.
Notes on pulse measurement by hand pulse
A minute current created by the contraction of the heart is recor-
ded by the hand sensors and analysed by the electronics
• Always cover the contact areas completely with both hands
• Avoid clasping jerkily
• Hold your hands calmly and avoid contraction and rubbing
on the contact areas.
Special training directions
The sequence of running exercises should be familiar to everyone.
Nevertheless, there are certain points that should be observed
when running:
• Always make sure the structure and condition of the unit are
correct before training.
• Only get on and off the unit when it is at a complete standstill
and hold the hand grips to do so.
• Fasten the cord of the safety tread-stop key to your clothing
before starting the treadmill.
• Train with the proper running or sports shoes.
• Running on a treadmill is different from running on normal
ground. Therefore, you should prepare yourself for the running
training with slow walking on the treadmill.
• Hold firmly onto the handlebars during your first training units
in order to avoid uncontrolled movements that could lead to a
fall. This applies especially to operating the computer while run-
ning.
• Beginners should not adjust the incline of the tread to too high
a position, in order to avoid overload.
• Run in as even a rhythm as possible.
• Only train in the middle of the tread.