9964-2701_ML.qxp
06/04/2007
4 / SPECIAL MESSAGES, DIFFICULTIES
•On first use
A special lamp appears.
Your installation blows a fuse.
Only one side works.
•On switching on
YOU OBSERVE THAT:
The hob does not operate and
the indicator lights on the con-
trol panel do not light up.
The hob does not function, the
information
is displayed.
•While in use
YOU OBSERVE THAT:
The hob has stopped operating
and is beeping approximately
every 10 seconds and a
F7 is displayed.
A series of small
displayed.
In case of breakage, cracks or even light fissures in the vitroceramic glass, take out
the fuses or turn off the circuit breaker for your hob to avoid the risk of electrical
shock.
Contact the After-Sales Service Department.
16:17
Page 29
POSSIBLE CAUSES:
Working normally.
The electrical connection of
your hob is incorrect.
POSSIBLE CAUSES:
The machine is not connected to
the power source. The power
source or connection is defective.
The hob is locked
POSSIBLE CAUSES:
There was an overflow or an
object is in contact with the
or
control panel.
or F7 is
The electronic circuits have
overheated.
29
EN
WHAT SHOULD YOU DO?
Nothing, the light disappears
after 30 seconds.
Check that it is set up
properly.
See
the
"Electrical
Connection" section.
WHAT SHOULD YOU DO?
Inspect the electrical cir-
cuit breaker and fuses.
See chapter on using the
child safety system
WHAT SHOULD YOU DO?
Clean the hob or remove
the object, then begin
cooking again.
See "Inserting" section.