Kärcher MC 130 Manual Del Usuario página 24

10 Floating beam
10.1 Hydraulic and electric connections
10.2 Operation
24
1 Swivel floating beam
2 Spread, floating beam
3 Coding connector, rear
4 Coding connector, front
1 Operating lever, floating beam
to the front (A) - Lower floating beam (set height)
to the rear (B) - Raise floating beam (set height)
to the left (C) - Swivel floating beam to the left
to the right (D) - Swivel floating beam to the right
2 Operating lever, floating beam spread
to the left (C) - Floating beam, increase width
to the right (D) - Floating beam, decrease width
3 Water pump on
4 Working hydraulics PTO on/off
5 Water pump performance +/-
6 Settings / storage
7 Motor speed
Working with the attachment kit
Switch on the work hydraulics PTO.

Switch on the water pump.

Select the water pump performance and save it.

Select the engine speed.

Use the control lever.

Start with the work.

9
-
EN