Medtronic GUARDIAN LINK Manual De Instrucciones página 13

5 When the transmitter light flashes green after connecting to the sensor, use your
pump to start the sensor. For more instructions, see your system user guide.
6 Attach the adhesive tab of the sensor to the transmitter.
7 After the transmitter is connected, consult your sensor user guide for details on
applying the required tape.
8 Follow the instructions that appear on the pump screen or in your system user
guide.
Disconnecting the transmitter from the sensor
Before proceeding, have your MiniMed™ insulin pump system user guide available.
To disconnect the transmitter from the sensor:
1 Carefully remove any tape from the transmitter and sensor.
2 Remove the adhesive tab from the top of the transmitter.
3 Hold the transmitter as shown, and pinch the flexible side
arms of the sensor between your thumb and forefinger.
4 Gently pull the transmitter away from the sensor.
5 Follow the instructions that appear on the pump or in your
system user guide.
Removing the sensor
Always refer to the sensor user guide for instructions on how to remove the sensor.
Reconnecting the transmitter to a sensor that is already inserted
You can reconnect your transmitter to the sensor you are currently using. Simply
connect your transmitter to the sensor that is already inserted. When the pump
detects the transmitter, confirm that you want to Reconnect Sensor. It may take a few
seconds to establish a connection when reconnecting a sensor. Reattach the
adhesive tab of the sensor to the transmitter and reapply any required tape. When
you reconnect a sensor, the sensor will go through another warm-up period before
you can calibrate it.
Tester
The tester is used to test the transmitter to make sure it is working. The tester is also
used as a required component to create a waterproof seal when cleaning the
transmitter. Properly connecting the tester to the transmitter ensures that fluids do not
come in contact with the connector pins inside the transmitter. Fluids can cause
connector pins to corrode and affect the performance of the transmitter.
-7-