Mounting The Cutting Attachment - Stihl FS-KM Manual De Instrucciones

Mounting the Blade
Slide the line limiting blade into the
N
guide on the skirt.
Insert the screw and tighten it down
N
firmly.
Mounting the Limit Stop
7
6
WARNING
Always fit the limit stop (6) when you use
a circular saw blade.
Position the limit stop (6) on the
N
gearbox flange.
Insert the screws (7) and tighten
N
them down firmly.
FS-KM
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Mounting Hardware for Cutting
Attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
If mounting hardware is packed with
machine
Mowing heads and metal cutting
attachments may be mounted.
3
4
5
1
2
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Removing the transport lock
Pull the hose (1) off the shaft (2).
N
If mounting hardware is not packed with
machine
2
Only mowing heads may be used which
mount directly to the shaft (2).
English
17