Mounting The Kombitool; Mounting The Cutting Blade - Stihl FCS-KM Manual De Instrucciones

English
Mounting the Gearbox
1
2
Loosen the clamp screw (1) on the
N
gearbox (2).
Push the drive tube (3) through the
N
clamp and into the gearbox – turn
the gearbox back and forth as
necessary.
Once the end of the drive tube is
N
inserted beyond the slot (see arrow)
in the clamp (5), push it full home as
far as stop.
Tighten down the clamp screw
N
moderately.
2
3
1
4
Line up the gearbox (2) on the drive
N
tube (3) so that the lug (arrow)
points vertically upwards when the
depth wheel (4) is vertical.
Tighten down the clamp screws (1)
N
firmly.
12

Mounting the KombiTool

2
3
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.

Mounting the Cutting Blade

1
N
3
4
N
Lay the power edger on its back so
that the blade mounting (1) faces
up.
5
6
4
2
3
Insert the stop pin (2) into the
hole (3) as far as stop – apply slight
pressure and turn back and forth
FCS-KM