Kit Assembly - Metra 99-7347B Manual De Instrucciones

ISO DIN radio provision with pocket
1. Snap the radio trim panel into the
factory radio surround panel. (Figure A)
2. Attach the pocket to the radio brackets
using the (4) supplied #8 x 3/8" Phillips
screws. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the completed
assembly, and secure it using screws
supplied with the radio. (Figure B)
5. Locate the factory wiring harness &
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly. (Figure C)

KIT ASSEMBLY

(Figure A)
(Figure B)
(Figure C)
ISO DDIN radio provision
1. Snap the radio trim panel into the
factory radio surround panel. (Figure A)
2. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure B)
3. Locate the factory wiring harness &
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
4. Reassemble the dash in reverse order of
disassembly. (Figure C)
(Figure A)
(Figure B)
(Figure C)
REV. 5/4/2018 INST99-7347B
3