Area Code; Factory Default - GE 25859 Guia Del Usuario

A C
REA ODE
NOTE: This setting may be made with the base and the handset.
If you enter your local 3-digit area code in the area code menu, it will not
appear in Caller ID messages you receive. Instead, you will see only the
local seven digit number. Calls you receive from outside your local area
code display as the full ten-digit number.
1. Press the flash/program button on your base until SET AREA CODE - - -
shows on the base display or press flash/prog on your handset until AREA
CODE - - - shows on the handset display. The default setting is - - -.
SET AREA CODE
Prompt displayed on the base
2. Use the touch-tone pad to enter your three digit area code.
NOTE: If you make a mistake, press the delete button on your base or the del/
chan button on your handset to erase the incorrect area code and repeat
above step.
3. Press flash/program or flash/prog again to store your selection. You will
hear a confirmation.
F D
ACTORY EFAULT
NOTE: This setting may be made with the base and the handset
As you become familiar with this system, you may prefer to use the
system's original settings. Follow the steps to return to the factory settings.
1. Press the flash/program button on the base until DEFAULT SETTING
1YES >2NO shows on the base unit display or press the flash/prog
button on the handset until DEFAULT > NO shows on the handset
display. The default setting is NO .
16
- - -

AREA CODE - - -

Prompt displayed on the handset