Local Area Code; Tone /Pulse Dialing; Ettings; Handset Operation - GE SPACEMAKER 26976 Guia Del Usuario

3. Press the flash/program button to store (if a change is made, you will
hear a confirmation tone).
L A
OCAL REA
1. Press flash/program button until SET AREA CODE - - - shows in the
display with the first digit blinking.
2. Use the dial pad to enter your local area code.
3. Press the flash/program button to store (if a change is made, you will
hear a confirmation tone).
T /P
ONE ULSE
Set your phone according to the type of service you are subscribed to.
1. Press flash/program button until SET TONE/PULSE >TONE PULSE
shows in the display.
2. Use the CID VOL(+) / CID VOL(-) arrow keys to select TONE or PULSE .
TONE is the default.
3. Press the flash/program button to store (if a change is made, you will
hear a confirmation tone).
D S
EFAULT

ETTINGS

If you prefer to use the system's original settings, follow the steps below
to return the answering system to the factory default settings.
1. Press flash/program button until DEFAULT SETTING YES NO shows
in the display.
2. Use the CID VOL(+) / CID VOL(-) arrow keys to select YES or NO. NO is
the default.
3. Press the flash/program button to confirm.
4. If you select YES , you will hear a confirmation tone, and the handset
resets to the following default values:
LANGUAGE

LOCAL AREA CODE

TONE/PULSE DIALING
H O
ANDSET
R
EGISTRATION
The handset and the Spacemaker® unit are pre-registered to the wall base
unit. If your handset is properly connected, but you cannot hear a dial tone
C
ODE
D
IALING
PERATION
ENGLISH
- - -
TONE
23