X-Rite DTP92 Guia Del Usuario página 31

Electronic Emission Notices (米国およびカナダでの使用のみ該当)
Federal Communications Commission Notice
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or service representative for help.
NOTE: Shielded interface cables must be used in order to maintain compliance with the desired FCC and
European emission requirements.
Industry Canada Compliance Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set
out in the interference-causing equipment standard entitled: "Digital Apparatus", ICES-003 of Industry Canada.
Avis de conformité aux normes d'Indstrie Canada
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils
numériques de Classe B prescrites dans la norme sur le matériel brouilleur : "Appareils numériques",
NMB-003 édictée par Industrie Canada.
エックスライト製品は、2005 年 8 月 13 日に発効された EU の WEEE 指令（電気電子機器
の廃棄処理規制）に準拠しています。詳細については を参照してください。
www.xrite.com
1