Doro PhoneEasy record 327cr Manual De Instrucciones página 11

Remote accessing
1.
Call the answer machine.
2.
Enter the remote code while the outgoing message is being
played. If the code is correct you will hear two short beeps.
3.
Select a remote access command (�ithin 10 seconds)�� see belo�.
Command
25 .............................Play new messages
2# .............................Play all messages
During playback
3# .............................Erase single message during playback
6# .............................Skip to previous message
7# .............................Skip to next message
8# .............................Repeat message
## .............................Stop playback
After playback
3# .............................Delete all messages
7# .............................Record new outgoing message. Stop
9# .............................On/off Two beeps = on and three beeps = off.
0# .............................Room monitoring in 30 seconds.
At the end of the manual these remote access commands are
available in credit card size format to cut out.
Please note!
If the machine doesn't respond to the remote access commands,
try pressing the telephone buttons for a longer or shorter time.
In normal cases, the answer machine should react to tones
approximately 0.5 – 1 seconds in length, but longer tones may be
necessary with certain telephone networks.
If you do not enter any remote access command, the answer
machine will disconnect after a few seconds.
If you listen to messages for longer than 2 minutes and 40
seconds, you will hear a tone. Press any key to continue.
English
Function
recording =7#
Press 5# to end.
11