Cleaning The Hob; Troubleshooting - AEG HE634070XB Manual De Instrucciones

7.2 Cleaning the hob

• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,
otherwise, the dirt can cause damage to
the hob. Take care to avoid burns. Use a
special hob scraper on the glass surface
at an acute angle and move the blade on
the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate or operate
the hob.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
Residual heat indicator does not
come on.
Automatic Heat Up does not op‐
erate.
You cannot activate the outer
ring.
There is a dark area on
the multiple zone.
• Remove shiny metallic discoloration:
Possible cause
The fuse is blown.
You touched 2 or more sensor fields
at the same time.
STOP+GO operates.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
The zone is hot.
The highest heat setting is set.
It is normal that there is a dark area
on the multiple zone.
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and a non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
use a solution of water with vinegar and
clean the glass surface with a cloth.
Remedy
Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Remove the object from the sensor
fields.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Let the zone become sufficiently cool.
The highest heat setting has the same
power as the function.
First, activate the inner ring by chang‐
ing the heat setting.
ENGLISH 13