Hach Polymetron 9611sc PO43– LR Operaciones página 12

Option Description
SIGNAL AVERAGE Selects the number of measurements used to
calculate an average measurement (1–5). This
reduces variability in measurements (default = 1) (no
average).
EDIT ANALYZER Changes the name that is shown on the top of the
NAME measurement screen (maximum of 16 characters).
EDIT CHANNEL Changes the name of the sample source that is
NAME shown on the measurement screen (maximum of
10 characters).
CONFIGURE Starts or stops measurements for individual sample
SEQUENCER sources. Sets the measurement order of the sample
(optional) sources when there is more than one sample
source.
SET DATE & TIME Sets the analyzer time and date.
DISPLAY SETUP Changes the language. Adjusts the order
measurements are shown. Adjusts the display
contrast settings.
DISABLE Stops scheduled maintenance alerts for individual
REMINDERS components. Options: tubing, stir bar, colorimeter
cell, air filter, stir motor, air relief valve, pinch valve,
air compressor, reagent valves, sample valves,
standard valves, colorimeter LED, fan filter, air
check valve.
MANAGE DEVICES Installs or removes input modules. Refer to
devices
INSTRUMENT Shows the analyzer information. Refer to
INFORMATION instrument information
CALCULATION Set up variables, parameters, units and formulas for
the analyzer. Refer to
on page 12.
SETUP OUTPUTS Selects and configures the 4–20 mA setup, the relay
setup and the error hold mode. Refer to
the outputs
12 English
Manage
on page 12 for more information.
View
on page 18.
Set up the calculation
Configure
on page 13 for more information.
Option Description
SETUP NETWORK Shows only if a network card is installed. The
(conditional) network card support is for Modbus, Profibus and
HART.
SECURITY SETUP Enables or disables the pass code (default =
HACH55).
AIR PURGE Enables the air purge when an outside air purge is
used on the analyzer (default = off). To use this
feature, make sure that the fan filter plug is installed.
Refer to the documentation that is supplied with the
air purge kit.
RESET DEFAULTS Sets the configuration to the factory defaults.
Manage devices
Install or remove input modules.
1. Select MANAGE DEVICES.
2. Select an option.
Option Description
SCAN FOR The system shows the connected devices.
DEVICES Note: If no device is connected, the system returns to
the main measurement screen.
DELETE DEVICE Removes the device when the device is no longer
connected.
Set up the calculation
Set up variables, parameters, units and formulas for the analyzer.
1. Select CALCULATION.
2. Select an option.
Option Description
SET VARIABLE X Selects the sensor referring to the variable X.
SET PARAMETER X Selects the parameter referring to the variable X.