Lanaform Back & Abs Manual De Instrucciones página 5

2. ASSEMBLY INSTRUCTIONS :
FIG.1 : Place the main assembly (1) on the floor and
attach the second assembly (2) with the flat washers
(Ø8) (12), nuts (M8) (10) and bolts (2xM8*38) (11).
On the other side, attach with the flat washers (Ø8)
(12) and allen screws (9).
FIG.3 : Position the grips (5) in the main assembly(1).
FIG.5 : Position the articulated assembly (7) on the
main assembly (1) as shown in the diagram.
FIG.2 : Align the two tubes (R = right and L = left)
(4) with the fixing holes.
FIG.4 : Attach the grips (5) and the tubes (4) with
the flat washers (Ø8) (12), nuts (M8) (10) and bolts
(2xM8*38) (11)+ (2xM9*35) (11').
FIG.6 : Attach the articulated assembly (7) with the
flat washers (Ø8) (12), nuts (13) and the allen screw
(9).
Back & Abs
EN
5