Allmatic BOOMY4 Manual Del Usuario página 47

5.3 INSTALLATION WITH LED KIT (OPTIONAL) - ONLY FOR 4 METERS VERSION
WARNING!
Make sure the board is not powered before making connections.
1. Take out the box of the control unit and remove the lid by unscrewing the screws (Fig.13).
2. Install the LED interface card in the appropriate slot (in the BOOMY 4 LED version the card is already installed) (Fig.14).
3. Drill two Ø 6 mm holes on the black plastic cap that covers the bottom of the boom (Fig.15).
4. Pass the LED power cables through the holes just made, through the cable hole of the cabinet and through the cable hole of
the control box.
5. Connect the led strips to the led card (Fig.16).
FIG. 13
FIG. 15
2 x Ø 6mm
6-1622396 - rev. 3 - 21/09/2021
1 2 3 4 5 6 7
LED STATUS
LED RADIO

20 21
G R +24
8 9 10 11 12 13 14 15 16 17
LED STATUS
SLOT FOR THE LED
INTERFACE BOARD
J1
G R +24
Description:
G LED channel GREEN
R LED channel RED
+24 LED power supply +24Vdc
PF1 Fuse T 1A
J1 PLUG-IN connector
J4
FIG. 14
J3
FUSE 2
FIG. 16
English - 11 / 36