5�2 Filling The Cleaning Vessel; 5�3 Choose Cleaning Time And Rpm; 5�4 Starting, Pausing, And Stopping Cleaning - Renfert SYMPRO Traducción Del Manual De Instrucciones Original

5.2 Filling the cleaning vessel
For use in the high-performance cleaning device:
⇒ Select the cleaning bowl suitable for the cleaning task (see 4�5 Application Table)�
EN
⇒ Fill the cleaning bowl with:
- the cleaning needles�
- objects to be cleaned
- cleaning liquid (please refer to the instructions for use in the booklet / product data sheet and safety
data sheet)�
⇒ Close the bowl (ensure that the lid / seal is correctly in place) and insert it into the unit�
Never operate the unit with the cleaning beaker open!
Only use the cleaning fluid once!
The object to be cleaned could cause a bacterial contamination of the cleaning fluid. Therefore,
the cleaning fluid must be replaced for each new cleaning process.
5.3 Choose cleaning time and RPM
⇒ Adjust the cleaning time with the + / - buttons (9, Fig� 1) (range 0 to 30 minutes)�
⇒ Set the speed using the speed selection key (8, Fig� 1)�
♦ The speed display (7, Fig� 1) shows the selected speed�
Refer to Table in Chapter 4.5 for recommended speed and cleaning time.
The cleaning time in the appliance will depend on the nature of the cleaning solution, the selected
RPM and the degree of soil and staining. It is advisable to check the results several times during
cleaning if you have no previous experience with this appliance.
In the case of particularly stubborn residues, an extended running time (+ max. 10 min.) and short,
manual cleaning with a hard toothbrush under running water can help to further improve the
cleaning results.
Never open the cleaning beaker in the device!
5.4 Starting, pausing, and stopping cleaning
⇒ Start cleaning with the Start / Pause button (10)�
♦ The appliance stops automatically when the set cleaning time
has elapsed�
♦ The remaining time is displayed in the indicator during clean-
ing�
• Cleaning can be stopped and restarted by pressing the Start /
Pause button�
• Once cleaning is stopped, the remaining cleaning time can be
adjusted�
• You can change the set RPM at any time during cleaning�
• Cleaning can be stopped at any time before the cleaning time
has elapsed by pressing the Stop button (11)�
♦ After the cleaning time has elapsed the indicator shows „00"�
⇒ Stop cleaning altogether by pressing the Stop button (11)�
♦ The display shows the previously set cleaning time�
To improve the cleaning performance, the sense of rotation will change every 30 seconds.
- 10 -
10 11
Fig. 2