Motion Alarm; Motion Alarm Setting Display; Setting The Motion Alarm - Oregon Scientific RMR939P Manual De Usuario

NOTE If no button is pressed, the alarm will
automatically silence after 2 minutes. It will then sound
again in 24 hours.

MOTION ALARM

MOTION ALARM SETTING DISPLAY

The motion sensor icon indicates the motion alarm
setting.
1
2
1. Code icon
2. Motion Sensor icon

SETTING THE MOTION ALARM

The motion alarm has a security / monitoring function,
whereby when the motion sensor detects movement, it
sets off the clock alarm for 5 minutes and the backlight
will turn on for 10 seconds. The clock will also show
which sensor has been activated - Ch.1 or Ch.2 will
appear in the top left hand corner of the display.
You can set the motion alarm to be activated over a set
period of time i.e. during night time, by entering values
next to the Start / Stop Hour in the process detailed
below. However, it is important that you set the Code on
the clock display to match the Code on the back of the
motion sensor(s) so that the items can interact with each
other. This process is also detailed below.
1. Press and hold MOTION ALARM for 2 seconds to
enter the Motion Alarm Setting Mode.
2. The Code will start flashing. Use the
to choose the same Code setting as that displayed
on the back of the motion sensor. Then press
MOTION ALARM to select your chosen option. The
start hour digits will start flashing.
3. Enter the value by pressing the
4. Confirm the entry by pressing the MOTION ALARM
button and move on to the next setting.
5. Repeat (3 and 4) to set the stop hour, beep / melody
and volume.
6. The motion alarm will be on automatically after setting.
16
and buttons
or buttons.