General Information; About These Instructions; Copyright; Subject To Change - Wilo Rexa CUT GI Instrucciones De Instalación Y Funcionamiento

1

General information

1.1

About these instructions

These installation and operating instructions are an in-
tegral part of the product. Read these instructions before
commencing work and keep them in an accessible place
at all times. Strict adherence to these instructions is a
precondition for the intended use and correct operation
of the product. All information and markings on the
product must be observed.
The language of the original operating instructions is
German. All other languages of these instructions are
translations of the original operating instructions.
1.2

Copyright

These installation and operating instructions have been
copyrighted by the manufacturer. Contents of any kind
may not be reproduced or distributed, or used for pur-
poses of competition and shared with others.
1.3

Subject to change

The manufacturer reserves the right to make technical
modifications to the device or individual components.
The illustrations used may differ from the original and are
intended as an example representation of the device.
1.4

Warranty

The specifications in the current "General Terms and
Conditions" apply to the warranty and the warranty
period. These can be found at www.wilo.com/legal
Any deviations must be contractually agreed and shall
then be given priority.
Claim to warranty
If the following points are complied with, the manufac-
turer is obligated to rectify every qualitative or con-
structive flaw:
▪ The defects are reported in writing to the manufacturer
within the warranty period.
▪ Application according to intended use.
▪ All monitoring devices are connected and tested before
commissioning.
Exclusion from liability
Exclusion from liability excludes all liability for personal
injury, material damage or financial losses. This exclusion
ensues as soon as one of the following applies:
▪ Inadequate configuration due to inadequate or incorrect
instructions by the operator or the client
▪ Non-compliance with installation and operating instruc-
tions
▪ Improper use
Installation and operating instructions Wilo-Rexa CUT GI
General information
2
2.1
▪ Incorrect storage or transport
▪ Incorrect installation or dismantling
▪ Insufficient maintenance
▪ Unauthorised repairs
▪ Inadequate construction site
▪ Chemical, electrical or electro-chemical influences
▪ Wear

Safety

This chapter contains basic information for the individual
phases of the life cycle. Failure to observe this informa-
tion carries the following risks:
▪ Injury to persons from electrical, mechanical and bacteri-
ological factors as well as electromagnetic fields
▪ Environmental damage from discharge of hazardous
substances
▪ Property damage
▪ Failure of important functions of the product
Failure to observe the information contained herein will
result in the loss of claims for damages.
The instructions and safety instructions in the other
chapters must also be observed!

Identification of safety instructions

These installation and operating instructions set out
safety instructions for preventing personal injury and
damage to property. These safety instructions are shown
differently:
▪ Safety instructions relating to personal injury start with a
signal word, are preceded by a corresponding symbol
and are shaded in grey.
DANGER
Type and source of the danger!
Consequences of the danger and instructions for
avoidance.
▪ Safety instructions relating to property damage start
with a signal word and are displayed without a symbol.
CAUTION
Type and source of the danger!
Consequences or information.
Signal words
▪ DANGER!
Failure to observe the safety instructions will result in
serious injuries or death!
en
91