Samoa 504 Serie Guía De Servicio Técnico Y Recambio página 2

EN
DESCRIPTION
Open hose reel for air, water (high or low pressure), oil or grease,
depending on model.
Uncoil the hose till the desired length. It can be locked by means of the
latch mechanism.
By gently pulling the hose, the latch is released and the hose is
automatically recoiled.
INSTALLATION
Wall or ceiling mounted hose reel, directly or by using a pivoting
bracket (Ref. 360 111) or a special bracket for installing several hose
reels (ref.: 360 115, 360 117, 360 118).
For smooth operation and longer life, position the hose guide arms as per
figure 2. This way, the hose is always pulled tangentially to the hose reel.
PERPENDICULAR REELING
Fig. 2
To move the hose guide arms and the hose outlet mouth, it is necessary to remove screws (1) (fig. 3). The spool and the hose guide arms will be
released from the base. Place the guide arms in desired position and replace screws.
2
850 836 R. 07/19
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
SIDE REELING
Fig. 3
WARNING: High pressure device for professional use only.
!
Keep body clear of nozzle and hose. Serious injury could occur.
Do not exceed max. W.P. and temperature of the lowest rated
system component. Disconnect air and release pressure in the
system before servicing.
WARNING: Before maintaining and/or repairing your Hose Reel
!
and/or any part of the system, you must disconnect the air to the
pump and open the dispensing valve until pressure is relieved.
The spring is always under great tension an could be propelled
from the case with enough force to cause serious bodily injury.
Try not to operate the power spring inside the hose reel.
1
1
TANGENTIAL REELING